Your shopping cart is empty!
ASTM International, 12/01/2009
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/12/2009
Pages:10
File Size:1 file , 480 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This procedure covers the determination of aldicarb, carbofuran, oxamyl and methomyl (referred to collectively as carbamates in this test method) in surface water by direct injection using liquid chromatography (LC) and detected with tandem mass spectrometry (MS/MS). These analytes are qualitatively and quantitatively determined by this method. This method adheres to multiple reaction monitoring (MRM) mass spectrometry.
1.2 This test method has been developed by US EPA Region 5 Chicago Regional Laboratory (CRL).
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 The Detection Verification Level (DVL) and Reporting Range for the carbamates are listed in Table 1.
Analyte
DVL (ng/L)†
Reporting Range (μg/L)
Aldicarb
100
1-100
Carbofuran
Oxamyl
Methomyl
† Measurement editorially corrected.
1.4.1 The DVL is required to be at a concentration at least 3 times below the Reporting Limit (RL) and have a signal/noise ratio greater than 3:1. Fig. 1 displays the signal/noise ratios of the primary single reaction monitoring (SRM) transitions and Fig. 2 displays the confirmatory SRM transitions at the DVLs for the carbamates.
1.4.2 The reporting limit is the concentration of the Level 1 calibration standard as shown in Table 2 for the carbamates.
Standard Specification for Concentric-Lay-Stranded Conductors of 8000 Series Aluminum Alloy for Subsequent Covering or Insulation
$30.00 $60.00
Standard Specification for Nickel-Coated, Copper-Clad Steel Wire for Electronic Application
Standard Specification for Unfaced Preformed Rigid Cellular Polyisocyanurate Thermal Insulation
Standard Test Method for Rubber Compounding Materials - ;Determination of Acidity in Sulfur
$26.00 $52.00
