• Your shopping cart is empty!

  • ASTM D7645-23

ASTM D7645-23

Standard Test Method for Determination of Aldicarb, Aldicarb Sulfone, Aldicarb Sulfoxide, Carbofuran, Methomyl, Oxamyl, and Thiofanox in Water by Liquid Chromatography/Tandem Mass Spectrometry (LC/MS/MS)

ASTM International, 04/15/2023

Publisher: ASTM

File Format: PDF

$31.00$63.00


Published:15/04/2023

Pages:14

File Size:1 file , 670 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of aldicarb, aldicarb sulfone, aldicarb sulfoxide, carbofuran, methomyl, oxamyl, and thiofanox (referred to collectively as carbamates in this test method) in water by direct injection using liquid chromatography (LC) and detected with tandem mass spectrometry (MS/MS). These analytes are qualitatively and quantitatively determined by this test method. This test method adheres to multiple reaction monitoring (MRM) mass spectrometry.
1.2 The Detection Verification Level (DVL) and Reporting Range for the carbamates are listed in Table 1.
1.2.1 The DVL is required to be at a concentration at least 3 times below the Reporting Limit (RL) and have a signal/noise ratio greater than 3:1. Fig. 1 displays the signal/noise ratios of the primary single reaction monitoring (SRM) transitions, and Fig. 2 displays the confirmatory SRM transitions at the DVLs for the carbamates.
1.3 Units-The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D7236-07(2013)

ASTM D7236-07(2013)

Standard Test Method for Flash Point by Small Scale Closed Cup Tester (Ramp Method)

$30.00 $60.00

ASTM D4300-01(2013)

ASTM D4300-01(2013)

Standard Test Methods for Ability of Adhesive Films to Support or Resist the Growth of Fungi

$31.00 $62.00

ASTM C1601-08

ASTM C1601-08

Standard Test Method for Field Determination of Water Penetration of Masonry Wall Surfaces

$30.00 $60.00

ASTM D4304-13

ASTM D4304-13

Standard Specification for Mineral and Synthetic Lubricating Oil Used in Steam or Gas Turbines

$30.00 $60.00