• ASTM D7672-14

ASTM D7672-14

Standard Specification for Evaluating Structural Capacities of Rim Board Products and Assemblies

ASTM International, 10/01/2014

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/10/2014

Pages:17

File Size:1 file , 290 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification provides procedures for testing and establishing the structural capacities of proprietary rim board products and assemblies for use in light-frame wood construction using I-joist or structural composite lumber joist framing. This specification does not apply to commodity rim board products.

1.2 This specification was developed in light of currently manufactured panel, structural composite lumber, and pre-fabricated I-joist rim board products as defined in 3.2. Materials that do not conform to the definitions of 3.2 are beyond the scope of this specification.

1.3 Fire safety, sound transmission, building envelope performance, and cutting/notching attributes of rim board products and assemblies fall outside the scope of this specification.

1.4 This specification primarily considers end use in dry service conditions, such as most protected framing members, where the equilibrium moisture content for solid-sawn lumber is less than 16 %.

1.5 This specification provides methods to establish “allowable stress” design resistances for use with the National Design Specification for Wood Construction (NDS). Derivation of design resistances from the test data in accordance with “load and resistance factor design” or “limit states design” are beyond the scope of this specification.

1.6 Quality control requirements are outside the scope of this Specification.

1.7 The performance of a rim board product will be affected by the constituent wood species, geometry, adhesive, and production parameters. Therefore, rim board products produced by each individual manufacturer shall be evaluated to determine their product properties, regardless of the similarity in characteristics to products produced by other manufacturers.

1.8 Where a manufacturer produces product in more than one facility, each production facility shall be evaluated independently. For additional production facilities, any revisions to the full qualification program in accordance with this specification shall be approved by an accredited, independent qualifying agency.

1.9 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.10 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D6155-19

ASTM D6155-19

Standard Specification for Nontraditional Coarse Aggregates for Asphalt Paving Mixtures

$22.00 $44.00

ASTM D3525-04(2010)

ASTM D3525-04(2010)

Standard Test Method for Gasoline Diluent in Used Gasoline Engine Oils by Gas Chromatography

$30.00 $60.00

ASTM E2035-10

ASTM E2035-10

Standard Terminology Relating to Forensic Psychophysiology

$25.00 $50.00

ASTM A194/A194M-11

ASTM A194/A194M-11

Standard Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both

$33.00 $67.00