Your shopping cart is empty!
ASTM International, 04/01/2016
Publisher: ASTM
File Format: PDF
$31.00$62.00
Published:01/04/2016
Pages:5
File Size:1 file , 88 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers the requirements for fully-formulated glycerin base coolants for cooling systems of heavy-duty engines. When concentrates are used at 40 to 60 % glycerin concentration by volume in water of suitable quality (see Appendix X1), or when prediluted glycerin base engine coolants (50 volume % min) are used without further dilution, they will function effectively during both winter and summer to provide protection against corrosion, cavitation, freezing, and boiling.
1.2 This specification is intended to cover the requirements for engine coolants prepared from virgin glycerin.
Note 1: This specification is based on the knowledge of the performance of engine coolants prepared from new or virgin ingredients that comply with Specification D7714.
1.3 The coolants governed by this specification are categorized as follows:
Coolant Type
Description
V-FF
Glycerin base concentrate
VI-FF
Glycerin predilute (50 vol %)
1.4 Coolant concentrates meeting this specification do not require addition of supplemental coolant additive (SCA) until the first maintenance interval when a maintenance dose of SCA is required to continue protection in certain heavy duty engine cooling systems, particularly those of the wet cylinder liner-in-block design. The SCA additions are defined by and are the primary responsibility of the engine manufacturer or vehicle manufacturer. If they provide no instructions, follow the SCA supplier's instructions.
1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Rubber Sheet Floor Covering Without Backing
$25.00 $50.00
Standard Test Method for Evaluating Pipeline Coating Patch Materials (Withdrawn 2007)
$29.00 $58.00
Standard Test Method for Relative Efficacy of Dynamic Solvent Systems for Dissolving Water-Formed Deposits
$30.00 $60.00
Standard Specification for Chromium-Nickel Stainless Steel Weaving and Knitting Wire
$26.00 $52.00