ASTM D7887-20

1.1 This guide is intended to clarify the selection, use, and description criteria of non-hazardous liquid substitutes used to replace liquid hazardous materials on packagings designs being subjected to United Nations (UN) performance-oriented packaging certification as required by United States Department of Transportation Title 49 Code of Federal Regulations (49 CFR) and the United Nations Recommendations on the Transport of Dangerous Goods (UN). This includes identification of the physical parameters of substitute non-hazardous liquid test fill materials that may affect packaging performance and test results and should be considered when selecting and describing a test fill material that conforms to the requirements of the Hazardous Materials Regulations (HMR).

1.2 This guide provides information to assist packaging users, manufacturers, and performance testing service suppliers regarding the types of physical properties that should be considered when selecting substitute liquid filling substances for the testing, certification, and manufacture of packagings under the United Nations packaging protocols as adopted by US DOT in 49 CFR HMR..

1.3 This guide provides the suggested minimum information concerning the physical characteristics of the filling substances that should be documented in the certification test report and notification to users to allow for test repeatability and analysis. Attention should be paid to the differences in physical characteristics of the substance used in the test compared to the materials transported.

1.4 This guide does not purport to address regulatory requirements regarding the compatibility of filling substances with transport packagings. Compatibility requirements must be assessed separately, but it should be noted that under certain national and international dangerous goods regulations, the selection of the filling substances for package performance testing may be prescribed with respect to chemical compatibility requirements.

1.5 The units of measurement are consistent with the HMR.

1.6 When testing packaging designs intended for hazardous materials (dangerous goods), the user of this guide shall be trained in accordance with 49 CFR §172.700 and other applicable hazardous materials regulations such as the ICAO Technical Instructions, IMDG Code, other applicable national or international dangerous goods regulations that govern the testing, manufacture and use of packagings authorized for the transportation of Dangerous Goods, and carrier rules such as the IATA Dangerous Goods Regulations.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.