Your shopping cart is empty!
ASTM International, 05/01/2017
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/05/2017
Pages:9
File Size:1 file , 210 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the determination and evaluation of flow properties, wear levels, contaminants, and oxidative condition of new and in-service lubricating grease.
1.2 This test method provides guidance on evaluating in-service grease samples, NLGI grades 00 to 3, for wear, consistency, contamination, and oxidation.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3.1 Exception-The exception to this will be where units of references were developed by the developers of the test equipment and necessary to report the results of the test.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Determination of 2,4-Toluene Diisocyanate (2,4-TDI) and 2,6-Toluene Diisocyanate (2,6-TDI) in Air (with 9-(N-Methylaminomethyl) Anthracene Method) (MAMA) in the Workplace
$30.00 $60.00
Standard Specification for Commercial Food Waste Disposers
$25.00 $50.00
Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
$26.00 $52.00
Standard Test Method for D-C Volume Resistivity of Glass
$29.00 $58.00
