• ASTM D8030/D8030M-16

ASTM D8030/D8030M-16

Standard Practice for Sample Preparation for GCCM

ASTM International, 01/01/2016

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/01/2016

Pages:6

File Size:1 file , 280 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This standard practice specifies a set of instructions for preparing samples of geosynthetic cementitious composite mat (GCCM) for index property testing.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.3.1 For purposes of comparing measured or calculated value(s) with specified limits, the measured or calculated value(s) shall be rounded to the nearest decimal or significant digits in the specified limits.

1.3.2 The procedures used to specify how data are collected/recorded or calculated in this practice are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be measured. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the users objectives; and it is common practice to increase or reduce the significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this practice to consider significant digits used in the analytical methods for engineering design.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Some specific hazards statements are given in Section 7 on Hazards.

More ASTM standard pdf

ASTM C1667-09

ASTM C1667-09

Standard Test Method for Using Heat Flow Meter Apparatus to Measure the Center-of-Panel Thermal Resistivity of Vacuum Panels

$30.00 $60.00

ASTM D4873-02(2009)

ASTM D4873-02(2009)

Standard Guide for Identification, Storage, and Handling of Geosynthetic Rolls and Samples

$26.00 $52.00

ASTM F1796-09

ASTM F1796-09

Standard Specification for High Voltage Detectors - ;Part 1 Capacitive Type to be Used for Voltages Exceeding 600 Volts AC

$29.00 $58.00

ASTM D3512/D3512M-16

ASTM D3512/D3512M-16

Standard Test Method for Pilling Resistance and Other Related Surface Changes of Textile Fabrics: Random Tumble Pilling Tester

$34.00 $68.00