ASTM D8123-22

1.1''These test methods are index tests to measure the opening size of a geohazard netting, or its components, or both, as it has been manufactured. They can be used for estimating the largest size of rock or other object that may pass through an individual opening in the geohazard netting without transferring load to the wire mesh or wire net and may also be used for quality control purposes. These test methods are not used to determine the maximum size rock or other object that the geohazard netting may contain through mobilization of the netting'''s strength. These test methods do not apply to the measurement of the opening size of a geosynthetic, such as a turf reinforcement mat or geotextile, that may be manufactured as a composite system with the geohazard netting.

1.2''Units'''The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only and are not considered standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this standard.

1.3''All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.