Your shopping cart is empty!
ASTM International, 04/01/2021
Publisher: ASTM
File Format: PDF
$36.00$72.00
Published:01/04/2021
Pages:19
File Size:1 file , 390 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method, commonly referred to as the L-37-1 test, describes a test procedure for evaluating the load-carrying capacity, wear performance, and extreme pressure properties of a gear lubricant in a hypoid axle under conditions of low-speed, high-torque operation.3
1.2''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1''Exceptions'''Where there is no direct SI equivalent such as National Pipe threads/diameters, tubing size, or where there is a sole source supply equipment specification.
1.2.1.1''The drawing in Annex A6 is in inch-pound units.
1.3''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are provided in 7.2 and 10.1.
1.4''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Joint Sealants, Hot Applied, Jet Fuel Resistant Types, for Portland Cement Concrete Pavements (Withdrawn 2012)
$25.00 $50.00
Standard Specification for Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, and Condenser Tubes
$30.00 $60.00
Standard Specification for Thermoplastic Polyethylene Insulation for Electrical Wire and Cable
$27.00 $54.00
Standard Specification for Chromium-Iron Sealing Alloys with 18 or 28 Percent Chromium
$29.00 $58.00