Your shopping cart is empty!
ASTM International, 05/01/2019
Publisher: ASTM
File Format: PDF
$55.00$111.00
Published:01/05/2019
Pages:89
File Size:1 file , 3.9 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method is commonly referred to as the Sequence VH3 test, and it has been correlated with the Sequence VG test. The Sequence VG test was previously correlated with vehicles used in stop-and-go service prior to 1996, particularly with regard to sludge and varnish formation.4 It is one of the test methods required to evaluate oils intended to satisfy the API SN, SN Plus performance category.
1.2 The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.
1.2.1 Exception-Where there is no direct SI equivalent such as screw threads, national pipe threads/diameters, tubing size, or specified single source equipment.
1.3 A table of contents follows:
Section
Scope
1
Referenced Documents
2
Terminology
3
Summary of Test Method
4
Significance and Use
5
Apparatus (General Description)
6
Apparatus (The Test Engine)
7
Sequence VH Test Engine
7.1
Required New Engine Parts
7.2
Reusable Engine Parts
7.3
Specially Fabricated Engine Parts
7.4
Special Engine Measurement and Assembly Equipment
7.5
Miscellaneous Engine Components-Preparation
7.6
Solvents and Cleaners Required
7.7
Assembling the Test Engine-Preparations
7.8
Assembling the Test Engine-Installations
7.9
Engine Installation on the Test Stand
7.10
Engine Fluids (Supply/Discharge Systems)
8
Intake Air
8.1
Fuel and Fuel System
8.2
Engine Oil and Engine Oil System
8.3
Coolants
8.4
Measurement Instrumentation
9
Temperatures
9.1
Pressures
9.2
Flow Rates
9.3
Fuel Consumption
9.4
Speed and Torque
9.5
Exhaust Gas
9.6
Humidity
9.7
Miscellaneous Laboratory Equipment
ASTM D2688-11 Standard Test Method for Corrosivity of Water in the Absence of Heat Transfer (Weight Loss Method) $30.00 $60.00 Add to Cart ASTM D7449/D7449M-08e1 Standard Test Method for Measuring Relative Complex Permittivity and Relative Magnetic Permeability of Solid Materials at Microwave Frequencies Using Coaxial Air Line $30.00 $60.00 Add to Cart ASTM A788/A788M-11 Standard Specification for Steel Forgings, General Requirements $33.00 $67.00 Add to Cart ASTM D6495-99 Standard Guide for Acceptance Testing Requirements for Geosynthetic Clay Liners $25.00 $50.00 Add to Cart
Standard Test Method for Corrosivity of Water in the Absence of Heat Transfer (Weight Loss Method)
$30.00 $60.00
Standard Test Method for Measuring Relative Complex Permittivity and Relative Magnetic Permeability of Solid Materials at Microwave Frequencies Using Coaxial Air Line
Standard Specification for Steel Forgings, General Requirements
$33.00 $67.00
Standard Guide for Acceptance Testing Requirements for Geosynthetic Clay Liners
$25.00 $50.00