• ASTM D8291-19

ASTM D8291-19

Standard Test Method for Evaluation of Performance of Automotive Engine Oils in the Mitigation of Low-Speed, Preignition in the Sequence IX Gasoline Turbocharged Direct-Injection, Spark-Ignition Engine

ASTM International, 11/01/2019

Publisher: ASTM

File Format: PDF

$47.00$94.00


Published:01/11/2019

Pages:58

File Size:1 file , 2.5 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This laboratory engine test evaluates the ability of an automotive engine to mitigate preignition in the combustion chambers in gasoline, turbocharged, direct-injection (GTDI) engines under low-speed and high-load operating conditions. This test method is commonly known as the Ford low-speed, preignition (LSPI) test.

1.1.1 In vehicles, equipped with relatively small GTDI spark-ignition engines, preignition has occasionally occurred when the vehicles are operated under low-speed and high-load conditions. Uncontrolled, preignition may cause destructive engine damage.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 Exceptions-Where there is no direct SI equivalent such as screw threads, national pipe threads/diameters, tubing size, wire gauge, or specified single source equipment.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E889-82(2023)

ASTM E889-82(2023)

Standard Test Method for Composition or Purity of a Solid Waste Materials Stream

$25.00 $50.00

ASTM B924-02(2022)

ASTM B924-02(2022)

Standard Specification for Seamless and Welded Nickel Alloy Condenser and Heat Exchanger Tubes With Integral Fins

$28.00 $57.00

ASTM F3002-22

ASTM F3002-22

Standard Specification for Design of the Command and Control System for Small Unmanned Aircraft Systems (sUAS)

$28.00 $57.00

ASTM D4866/D4866M-88(2023)

ASTM D4866/D4866M-88(2023)

Standard Performance Specification for Coal-Tar Pitch Emulsion Pavement Sealer Mix Formulations Containing Mineral Aggregates and Optional Polymeric Admixtures

$25.00 $50.00