• ASTM D8291-20a

ASTM D8291-20a

Standard Test Method for Evaluation of Performance of Automotive Engine Oils in the Mitigation of Low-Speed, Preignition in the Sequence IX Gasoline Turbocharged Direct-Injection, Spark-Ignition Engine

ASTM International, 07/01/2020

Publisher: ASTM

File Format: PDF

$48.00$97.00


Published:01/07/2020

Pages:57

File Size:1 file , 2.6 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This laboratory engine test evaluates the ability of an automotive engine to mitigate preignition in the combustion chambers in gasoline, turbocharged, direct-injection (GTDI) engines under low-speed and high-load operating conditions. This test method is commonly known as the Ford low-speed, preignition (LSPI) test.

1.1.1 In vehicles, equipped with relatively small GTDI spark-ignition engines, preignition has occasionally occurred when the vehicles are operated under low-speed and high-load conditions. Uncontrolled, preignition may cause destructive engine damage.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 Exceptions-Where there is no direct SI equivalent such as screw threads, national pipe threads/diameters, tubing size, wire gauge, or specified single source equipment.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM A577/A577M-90(2001)

ASTM A577/A577M-90(2001)

Standard Specification for Ultrasonic Angle-Beam Examination of Steel Plates

$26.00 $52.00

ASTM B248M-06

ASTM B248M-06

Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar [Metric]

$33.00 $67.00

ASTM B411/B411M-06

ASTM B411/B411M-06

Standard Specification for Copper-Nickel-Silicon Alloy Rod and Bar

$26.00 $52.00

ASTM E1034-95(2001)

ASTM E1034-95(2001)

Standard Specification for Nuclear Facility Transient Worker Records

$25.00 $50.00