• ASTM D8355-21

ASTM D8355-21

Standard Test Methods for Flammability of Electrical Insulating Materials Used for Sleeving or Tubing

ASTM International, 03/31/2021

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:31/03/2021

Pages:8

File Size:1 file , 150 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''This is a fire-test-response standard.

1.2''This fire test response standard contains various tests applicable to electrical insulation materials used for sleeving or for tubing (including heat-shrinkable tubing).

1.2.1''Test methods C and D are applicable to heat-shrinkable tubing only.

1.3''Use the values stated in SI units in referee decisions; see IEEE/ASTM SI-10. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.4''This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.5''Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.6''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F3253-23

ASTM F3253-23

Standard Specification for Crosslinked Polyethylene (PEX) Tubing with Oxygen Barrier for Hot- and Cold-Water Hydronic Distribution Systems

$31.00 $63.00

ASTM A815/A815M-23

ASTM A815/A815M-23

Standard Specification for Wrought Ferritic, Ferritic/Austenitic, and Martensitic Stainless Steel Piping Fittings

$28.00 $57.00

ASTM B949-23

ASTM B949-23

Standard Specification for General Requirements for Zinc and Zinc Alloy Products

$28.00 $57.00

ASTM F2735-23

ASTM F2735-23

Standard Specification for Plastic Insert Fittings For SDR9 Cross-linked Polyethylene (PEX) and Polyethylene of Raised Temperature (PE-RT) Tubing

$28.00 $57.00