1.1 This practice covers the calibration and verification of Dynamic Imaging Analyzers (analyzers) using catalytic and non-catalytic reference materials. The measurement range of analyzers covers from 500 µm to 20 000 µm.
1.2 This practice may also be used to analyze catalytic materials once the analyzer has been calibrated and verified.
1.3 Units-The values stated in SI units are to be regarded as standard; however, English and mesh units are also acceptable with conversions provided in Appendix X3.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
More ASTM standard pdf
ASTM C1710-09
Standard Guide for Installation of Flexible Closed Cell Preformed Insulation in Tube and Sheet Form
$29.00 $58.00
ASTM D5349-95(2001)
Standard Test Method for Determination of the Moisture and Volatile Content of Sulfonated and Sulfated Oils by Hot-Plate Method
$26.00 $52.00
ASTM D5586-95
Standard Tables of Body Measurements for Women Aged 55 and Older (All Figure Types)
$32.00 $65.00