• ASTM D8501-23

ASTM D8501-23

Standard Classification System for and Basis for Specification for Unfilled Poly(Ether Ketone Ketone) (PEKK) Materials for Molding, Extrusion, Composites, Powder Coating and Additive Manufacturing

ASTM International, 08/01/2023

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/08/2023

Pages:7

File Size:1 file , 300 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers poly(ether ketone ketone) materials, commonly referred to as PEKK, which are suitable for molding, extrusion, composites, powder coating and additive manufacturing. Only materials in this Class 6-8 are covered by this specification. This classification system provides requirements for the use of regrind or reprocessed materials.
1.2 This specification covers thermoplastic resin materials supplied in pellet as well as powder form.
1.3 This specification applies only to PEKK copolymers, without any additional fillers or inorganic additives, alloys, or treatments for modification of attributes.
1.4 This classification system and subsequent line callout (specification) are intended to provide means of calling out poly(ether ketone ketone) materials used in the fabrication of end items or parts.
1.5 Poly(ether ketone ketone) (PEKK) is a member of the poly (aryl ether ketone) or PAEK polymer family. PEKK has a broad range of repeat unit combinations of Isophthaloyl and Terephthaloyl repeat units. This standard classifies the polymer options.
1.6 The values stated in SI units, as detailed in IEEE/ASTM S-10, are to be regarded as the standard. The values given in parentheses are for information only.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
Note 2: PEKK is a thermoplastic polymer. Testing conditions can affect the technical results. Specimens prepared by techniques different than prescribed in this specification can have properties that vary from the values specified.
1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D4508-04a

ASTM D4508-04a

Standard Test Method for Chip Impact Strength of Plastics

$30.00 $60.00

ASTM A484/A484M-03

ASTM A484/A484M-03

Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings

$33.00 $67.00

ASTM D4751-04

ASTM D4751-04

Standard Test Method for Determining Apparent Opening Size of a Geotextile

$30.00 $60.00

ASTM B926-03

ASTM B926-03

Standard Method for Pinhole Determination in Aluminum and Aluminum Alloy Plain Foil by Means of a Light Table

$25.00 $50.00