• ASTM D876-09

ASTM D876-09

Standard Test Methods for Nonrigid Vinyl Chloride Polymer Tubing Used for Electrical Insulation

ASTM International, 10/01/2009

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/10/2009

Pages:13

File Size:1 file , 190 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods cover the testing of general-purpose (Grade A), low-temperature (Grade B), and high-temperature (Grade C) nonrigid vinyl chloride polymer tubing, or its copolymers with other materials, for use as electrical insulation. For the purpose of these test methods nonrigid tubing shall be tubing having an initial elongation in excess of 100 % at break.

Note 1 - These test methods are similar but not identical to those in IEC 60684-2.

1.2 The values stated in inch-pound units are to be regarded as standard, except for temperature, which shall be expressed in degrees Celsius. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The procedures appear in the following sections:


Procedure

Section
ASTM Reference Standard
Brittleness Temperature 43-45 D746
Corrosion Tests 74-85 D1000
Dielectric Breakdown Voltage at High Humidity 65-73 E104
Dielectric Breakdown Voltage 58-64 D149
Dimensional Tests 8-14 D374
Effect of Elevated Temperatures 25-36 D412
Flammability Test 15-21
Oil Resistance Test 35-42 D471
Penetration Test 46-51
Sampling 6
Strain Relief Test 68-73
Tension Test 22-24 D412
Test Conditions 7
Volume Resistivity 52-57 D257

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5.

1.5 For fire test caveats, see Section 15.

15.1 This is a fire-test-response standard. The test procedure described measures the resistance of the tubing to ignition or the spread of flame after ignition when tested under the specified conditions.

15.2 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

15.3 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

25.1 The effect of elevated temperature is indicated by the changes in ultimate elongation and weight caused by exposure of the tubing to elevated temperatures for a specified time under controlled conditions of air circulation.

More ASTM standard pdf

ASTM D3939/D3939M-13

ASTM D3939/D3939M-13

Standard Test Method for Snagging Resistance of Fabrics (Mace)

$30.00 $60.00

ASTM D6866-08

ASTM D6866-08

Standard Test Methods for Determining the Biobased Content of Solid, Liquid, and Gaseous Samples Using Radiocarbon Analysis

$33.00 $67.00

ASTM F2087-13

ASTM F2087-13

Standard Specification for Packing, Fiberglass, Braided, Rope, and Wick

$25.00 $50.00

ASTM E1654-94(2013)

ASTM E1654-94(2013)

Standard Guide for Measuring Ionizing Radiation-Induced Spectral Changes in Optical Fibers and Cables for Use in Remote Raman FiberOptic Spectroscopy

$31.00 $62.00