Your shopping cart is empty!
ASTM International, 09/01/2006
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/09/2006
Pages:2
File Size:1 file , 48 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice is intended for determining the temperature at a specified point or points on the surface of the cavity and base of a mold for plastics. By determining the temperature at as many points as deemed necessary, the overall temperature condition of the surface can be determined.
1.2 The values stated in SI units are to be regarded as standard. The values in brackets are given for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
There is no similar ISO standard.
Standard Test Method for Nickel and Vanadium in FCC Equilibrium Catalysts by Hydrofluoric/Sulfuric Acid Decomposition and Atomic Spectroscopic Analysis
$28.00 $56.00
Standard Practice for Soil Sample Preparation for the Determination of Radionuclides
$26.00 $52.00
Standard Test Method for the Determination of Total Hydrogen Content of Uranium Oxide Powders and Pellets by Carrier Gas Extraction
Standard Test Methods for Evaluating Coatings For High Temperature Service
