Your shopping cart is empty!
ASTM International, 11/15/2012
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:15/11/2012
Pages:2
File Size:1 file , 50 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice is intended for determining the temperature at a specified point or points on the surface of the cavity and base of a mold for plastics. By determining the temperature at as many points as deemed necessary, the overall temperature condition of the surface can be determined.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM Book of Standards - Section 10 - Electrical Insulation and Electronics (Vols 10.01-10.04)
$108.00 $217.35
Standard Test Method for Determination of Nitrogen Oxides, Carbon Monoxide, and Oxygen Concentrations in Emissions from Natural Gas-Fired Reciprocating Engines, Combustion Turbines, Boilers, and Process Heaters Using Portable Analyzers
$30.00 $60.00
Standard Test Method for Measuring Load Induced Subsidence of Intervertebral Body Fusion Device Under Static Axial Compression
$29.00 $58.00
Standard Practice for Conducting Proficiency Tests in the Chemical Analysis of Metals, Ores, and Related Materials
