• ASTM E108-16

ASTM E108-16

Standard Test Methods for Fire Tests of Roof Coverings

ASTM International, 10/01/2016

Publisher: ASTM

File Format: PDF

$32.00$65.00


Published:01/10/2016

Pages:13

File Size:1 file , 380 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This fire-test-response standard covers the measurement of the relative fire characteristics of roof coverings exposed to simulated fire sources originating outside the building. It is applicable to roof coverings intended for installation on either combustible or noncombustible roof decks when applied as intended for use. The following test methods are included:

1.1.1 Intermittent flame exposure test.

1.1.2 Spread of flame test.

1.1.3 Burning brand test.

1.1.4 Flying brand test.

1.1.5 Rain test.

1.2 Three classes of fire test exposure are described:

1.2.1 Class A Tests are applicable to roof coverings that are expected to be effective against severe fire exposure, afford a high degree of fire protection to the roof deck, do not slip from position, and are not expected to present a flying brand hazard.

1.2.2 Class B Tests are applicable to roof coverings that are expected to be effective against moderate fire exposure, afford a moderate degree of fire protection to the roof deck, do not slip from position, and are not expected to present a flying brand hazard.

1.2.3 Class C Tests are applicable to roof coverings that are effective against light fire exposure, afford a light degree of fire protection to the roof deck, do not slip from position, and are not expected to present a flying brand hazard.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled laboratory conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products or assemblies under actual fire conditions.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.6 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.7 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of this standard.

More ASTM standard pdf

ASTM D3773-07

ASTM D3773-07

Standard Test Methods for Length of Woven Fabric

$26.00 $52.00

ASTM B783-19

ASTM B783-19

Standard Specification for Materials for Ferrous Powder Metallurgy (PM) Structural Parts

$39.00 $79.00

ASTM D7365-09

ASTM D7365-09

Standard Practice for Sampling, Preservation and Mitigating Interferences in Water Samples for Analysis of Cyanide

$33.00 $67.00

ASTM A775/A775M-16

ASTM A775/A775M-16

Standard Specification for Epoxy-Coated Steel Reinforcing Bars

$33.00 $67.00