Your shopping cart is empty!
ASTM International, 06/08/1987
Publisher: ASTM
File Format: PDF
$31.00$62.00
Published:08/06/1987
Pages:7
File Size:1 file , 57 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This guide establishes procedures and test methods for conducting an on-site inspection and acceptance test of an installed domestic hot water system (DHW) using flat plate, concentrating-type collectors or tank absorber systems.
1.2 It is intended as a simple and economical acceptance test to be performed by the system installer or an independent tester to verify that critical components of the system are functioning and to acquire baseline data reflecting overall short term system heat output.
1.3 This guide is not intended to generate accurate measurements of system performance (see ASHRAE standard 95-1981 for a laboratory test) or thermal efficiency.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
IEEE/ASTM SI 10 American National Standard for Metric Practice
$49.00 $98.00
Standard Specification for Zinc-Coated Steel Chain-Link Fence Fabric
$26.00 $52.00
Standard Practice for Use of Apparatus for the Determination of Length Change of Hardened Cement Paste, Mortar, and Concrete
$30.00 $60.00
Standard Test Method for Pilling Resistance and Other Related Surface Changes of Textile Fabrics: Brush Pilling Tester