• ASTM E1251-07

ASTM E1251-07

Standard Test Method for Analysis of Aluminum and Aluminum Alloys by Atomic Emission Spectrometry

ASTM International, 06/01/2007

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/06/2007

Pages:10

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method describes the analysis of aluminum and its alloys by atomic emission spectrometry. The aluminum specimen to be analyzed may be in the form of a chill cast disk, casting, foil, sheet, plate, extrusion or some other wrought form or shape. The elements covered in the scope of this method are listed in the table below.

Note 1

The concentration ranges given in the above scope were established through cooperative testing (ILS) of selected reference materials. The range shown for each element does not demonstrate the actual usable analytical range for that element. The usable analytical range may be extended higher or lower based on individual instrument capability, spectral characteristics of the specific element wavelength being used and the availability of appropriate reference materials.

1.2 This test method is suitable primarily for the analysis of chill cast disks as defined in Practices E 716. Other forms may be analyzed, provided that: (1) they are sufficiently massive to prevent undue heating, (2) they allow machining to provide a clean, flat surface, which creates a seal between the specimen and the spark stand, and (3) reference materials of a similar metallurgical condition and chemical composition are available.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific safety and health statements are given in Section 10.

More ASTM standard pdf

ASTM F2135-01(2012)

ASTM F2135-01(2012)

Standard Specification for Molded Drain, Waste, and Vent (DWV) Short-Pattern Plastic Fittings

$29.00 $58.00

ASTM A529/A529M-01

ASTM A529/A529M-01

Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality

$26.00 $52.00

ASTM E396-12e1

ASTM E396-12e1

Standard Test Methods for Chemical Analysis of Cadmium

$33.00 $67.00

ASTM Volume 02.02:2008

ASTM Volume 02.02:2008

ASTM Book of Standards Volume 02.02: Nonferrous Metal Products: Aluminum and Magnesium Alloys

$115.00 $230.28