• ASTM E141-10(2018)

ASTM E141-10(2018)

Standard Practice for Acceptance of Evidence Based on the Results of Probability Sampling

ASTM International, 04/01/2018

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/04/2018

Pages:6

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice presents rules for accepting or rejecting evidence based on a sample. Statistical evidence for this practice is in the form of an estimate of a proportion, an average, a total, or other numerical characteristic of a finite population or lot. It is an estimate of the result which would have been obtained by investigating the entire lot or population under the same rules and with the same care as was used for the sample.

1.2 One purpose of this practice is to describe straightforward sample selection and data calculation procedures so that courts, commissions, etc. will be able to verify whether such procedures have been applied. The methods may not give least uncertainty at least cost, they should however furnish a reasonable estimate with calculable uncertainty.

1.3 This practice is primarily intended for one-of-a-kind studies. Repetitive surveys allow estimates of sampling uncertainties to be pooled; the emphasis of this practice is on estimation of sampling uncertainty from the sample itself. The parameter of interest for this practice is effectively a constant. Thus, the principal inference is a simple point estimate to be used as if it were the unknown constant, rather than, for example, a forecast or prediction interval or distribution devised to match a random quantity of interest.

1.4 A system of units is not specified in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM B605-95a(1999)

ASTM B605-95a(1999)

Standard Specification for Electrodeposited Coatings of Tin-Nickel Alloy

$29.00 $58.00

ASTM B579-73(1999)

ASTM B579-73(1999)

Standard Specification for Electrodeposited Coatings of Tin-Lead Alloy (Solder Plate)

$29.00 $58.00

ASTM B19-01

ASTM B19-01

Standard Specification for Cartridge Brass Sheet, Strip, Plate, Bar, and Disks (Blanks)

$30.00 $60.00

ASTM C1259-01

ASTM C1259-01

Standard Test Method for Dynamic Young's Modulus, Shear Modulus, and Poisson's Ratio for Advanced Ceramics by Impulse Excitation of Vibration

$33.00 $67.00