Your shopping cart is empty!
ASTM International, 10/15/2012
Publisher: ASTM
File Format: PDF
$41.00$83.00
Published:15/10/2012
Pages:22
File Size:1 file , 1.3 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice establishes minimum requirements for magnetic particle testing used for the detection of surface or slightly subsurface discontinuities in ferromagnetic material. Guide E709 can be used in conjunction with this practice as a tutorial.
1.2 The magnetic particle testing method is used to detect cracks, laps, seams, inclusions, and other discontinuities on or near the surface of ferromagnetic materials. Magnetic particle testing may be applied to raw material, billets, finished and semi-finished materials, welds, and in-service parts. Magnetic particle testing is not applicable to non-ferromagnetic metals and alloys such as austenitic stainless steels. See Appendix X1 for additional information.
1.3 All areas of this Practice may be open to agreement between the Cognizant Engineering Organization and the supplier, or specific direction from the Cognizant Engineering Organization.
1.4 This standard is a combined standard, an ASTM standard in which rationalized SI units and inch-pound units are included in the same standard, with each system of units to be regarded separately as standard.
1.4.1 Units - The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Blocking Resistance of Architectural Paints
$26.00 $52.00
Standard Practice for Injection Molding Test Specimens of Thermoplastic Molding and Extrusion Materials
$30.00 $60.00
Standard Test Method for Linearity of Fluorescence Measuring Systems
$27.00 $54.00
Standard Specification for Aluminum Bronze Sheet, Strip, and Rolled Bar
