• ASTM E1448/E1448M-09(2023)

ASTM E1448/E1448M-09(2023)

Standard Practice for Calibration of Systems Used for Measuring Vehicular Response to Pavement Roughness

ASTM International, 03/01/2023

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/03/2023

Pages:9

File Size:1 file , 230 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice describes equipment and procedures for the calibration of systems used for measuring vehicular response to pavement roughness. Such systems are referred to as response-type systems. (See Test Method E1082.)
1.2 The response-type system includes the driven vehicle, the driver and contents of the vehicle, the towed trailer (if one is used with the system), and a device called a road meter that measures the vehicle response to pavement roughness. The road meter may be mounted in an automobile, van, or in a towed trailer. Response-type (road meter) devices covered in this practice include: devices measuring the relative axle-body motion of a vehicle, devices measuring the vertical acceleration of the vehicle body, and devices measuring the vertical acceleration of the vehicle axle.
1.3 The calibration procedures described in this practice are limited to the use of the simulations described in Practice E1170.
1.4 This practice is not intended to apply to pavement roughness measuring equipment whose output is not influenced by the response of the host vehicle.
1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E3280-22

ASTM E3280-22

Standard Guide for the Safe Use of Table Saws

$44.00 $89.00

ASTM F3288/F3288M-20

ASTM F3288/F3288M-20

Standard Specification for MRS-Rated Metric- and Inch-sized Crosslinked Polyethylene (PEX) Pressure Pipe

$28.00 $56.00

ASTM E1681-03(2020)

ASTM E1681-03(2020)

Standard Test Method for Determining Threshold Stress Intensity Factor for Environment-Assisted Cracking of Metallic Materials

$38.00 $76.00

ASTM D297-21

ASTM D297-21

Standard Test Methods for Rubber Products--Chemical Analysis

$39.00 $78.00