Your shopping cart is empty!
ASTM International, 04/01/2013
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/04/2013
Pages:7
File Size:1 file , 180 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods2 cover the determination of the properties of flexible membranes to be used as vapor retarders in contact with earth under concrete slabs, against walls, or as ground cover in crawl spaces. The test methods are applicable primarily to plastic films and other flexible sheets. The materials are not intended to be subjected to sustained hydrostatic pressure. The procedures simulate conditions to which vapor retarders may be subjected prior to and during installation, and in service.
1.2 The test methods included are:
Section
Water-Vapor Transmission of Material as Received
7
Water-Vapor Transmission after Wetting and Drying and after Long- Time Soaking
8
Tensile Strength
9
Resistance to Puncture
10
Resistance to Plastic Flow and Elevated Temperature
11
Effect of Low Temperatures on Flexibility
12
Resistance to Deterioration from Organisms and Substances in Con- tacting Soil
13
Resistance to Deterioration from Petroleum Vehicles for Soil Poisons
14
Resistance to Deterioration from Exposure to Ultraviolet Light
15
Resistance to Flame Spread
16
Report
17
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM Book of Standards Volume 14.05 Statistical Methods; Hazard Potential of Chemicals; Thermal Measurements; Manufacture of Pharmaceutical and Biopharmaceutical Products
$103.00 $206.42
Standard Specification for Pure Palladium Electrical Contact Material
$22.00 $44.00
Standard Guide for Process Understanding Related to Pharmaceutical Manufacture and Control
$28.00 $57.00
Standard Test Methods for Complex Permittivity (Dielectric Constant) of Solid Electrical Insulating Materials at Microwave Frequencies and Temperatures to 1650oC
$34.00 $69.00
