• ASTM E1677-23

ASTM E1677-23

Standard Specification for Air Barrier (AB) Material or Assemblies for Low-Rise Framed Building Walls

ASTM International, 07/01/2023

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/07/2023

Pages:6

File Size:1 file , 290 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers minimum performances and specification criteria for an air barrier (AB) material or system for framed walls of low-rise buildings. The intended users are purchasers of the AB, specifiers of the AB and regulatory groups. The provisions contained in this specification are intended to allow the user to design the wall performance criteria and increase AB specifications to accommodate a particular climate location, function, or design of the intended building. Air barrier performance and specification minimums were selected with the service life of the building wall in mind.
1.2 This specification focuses on ABs for opaque walls. Other areas of the exterior envelope, such as roofs, floors, and interfaces between these areas are not included in this specification.
1.3 This specification does not address air leakage into the wall cavity, that is, windwashing. No standardized test has been developed that adequately identifies all of the influencing factors and measures the impact of this effect on the wall's thermal performance.
1.4 The specifications in this standard are not intended to be utilized for energy load calculations and are not based on an expected level of energy consumption.
1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.6 The following safety hazards caveat pertains only to the test method portion, Annex A1, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM C50-00(2006)

ASTM C50-00(2006)

Standard Practice for Sampling, Sample Preparation, Packaging, and Marking of Lime and Limestone Products

$30.00 $60.00

ASTM D1140-00(2006)

ASTM D1140-00(2006)

Standard Test Methods for Amount of Material in Soils Finer than No. 200 (75- micro m) Sieve

$26.00 $52.00

ASTM E640-06

ASTM E640-06

Standard Test Method for Preservatives in Water-Containing Cosmetics

$26.00 $52.00

ASTM D2923-06

ASTM D2923-06

Standard Test Method for Rigidity of Polyolefin Film and Sheeting

$26.00 $52.00