• ASTM E1876-07

ASTM E1876-07

Standard Test Method for Dynamic Young's Modulus, Shear Modulus, and Poisson's Ratio by Impulse Excitation of Vibration

ASTM International, 06/01/2007

Publisher: ASTM

File Format: PDF

$32.00$65.00


Published:01/06/2007

Pages:15

File Size:1 file , 240 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers determination of the dynamic elastic properties of elastic materials at ambient temperatures. Specimens of these materials possess specific mechanical resonant frequencies that are determined by the elastic modulus, mass, and geometry of the test specimen. The dynamic elastic properties of a material can therefore be computed if the geometry, mass, and mechanical resonant frequencies of a suitable (rectangular or cylindrical geometry) test specimen of that material can be measured. Dynamic Young's modulus is determined using the resonant frequency in either the flexural or longitudinal mode of vibration. The dynamic shear modulus, or modulus of rigidity, is found using torsional resonant vibrations. Dynamic Young's modulus and dynamic shear modulus are used to compute Poisson's ratio.

1.2 Although not specifically described herein, this test method can also be performed at cryogenic and high temperatures with suitable equipment modifications and appropriate modifications to the calculations to compensate for thermal expansion.

1.3 There are material specific ASTM standards that cover the determination of resonance frequencies and elastic properties of specific materials by sonic resonance or by impulse excitation of vibration. Test Methods C 215, C 623, C 747, C 848, C 1198, and C 1259 may differ from this test method in several areas (for example; sample size, dimensional tolerances, sample preparation). The testing of these materials shall be done in compliance with these material specific standards. Where possible, the procedures, sample specifications and calculations are consistent with these test methods.

1.4 The values stated in SI units are to be regarded as the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM E2680-09

ASTM E2680-09

Standard Test Method for Appearance of Clear, Transparent Liquids (Visual Inspection Procedure)

$26.00 $52.00

ASTM E329-07

ASTM E329-07

Standard Specification for Agencies Engaged in Construction Inspection and/or Testing

$30.00 $60.00

ASTM F2124-01

ASTM F2124-01

Standard Practice for Testing Ladder Treestand, Tripod Treestand and Climbing Stick Load Capacity

$25.00 $50.00

ASTM D7706-17

ASTM D7706-17

Standard Practice for Rapid Screening of VOC Emissions from Products Using Micro-Scale Chambers

$37.00 $75.00