Your shopping cart is empty!
ASTM International, 03/15/2014
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:15/03/2014
Pages:6
File Size:1 file , 110 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures for assessing the volatility of solids and liquids at given temperatures using thermogravimetry under prescribed experimental conditions. Results of these test methods are obtained as volatility rates expressed as mass per unit time. Rates ≥ 5 μg/min are achievable with these test methods.
1.2 Temperatures typical for these test methods are within the range from 25°C to 500°C. This temperature range may differ depending upon the instrumentation used.
1.3 These test methods are intended to provide a value for the volatility rate of a sample using a thermogravimetric analysis measurement on a single representative specimen. It is the responsibility of the user of these test methods to determine the need for and the number of repetitive measurements on fresh specimens necessary to satisfy end use requirements.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 There is no ISO method equivalent to this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of these test methods to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Nickel Plate, Sheet, and Strip
$24.00 $48.00
Standard Terminology Relating to Plastic Piping Systems
$38.00 $76.00
Standard Test Method for Penetration of Bituminous Materials
$23.00 $46.00
Standard Test Method for High Speed Puncture Properties of Plastic Films Using Load and Displacement Sensors
$25.00 $50.00