• ASTM E2029-11

ASTM E2029-11

Standard Test Method for Volumetric and Mass Flow Rate Measurement in a Duct Using Tracer Gas Dilution

ASTM International, 09/01/2011

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/09/2011

Pages:10

File Size:1 file , 130 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method describes the measurement of the volumetric and mass flow rate of a gas stream within a duct, stack, pipe, mine tunnel, or flue using a tracer gas dilution technique. For editorial convenience all references in the text will be to a duct, but it should be understood that this could refer equally well to a stack, pipe, mine tunnel, or flue. This test method is limited to those applications where the gas stream and the tracer gas can be treated as ideal gases at the conditions of the measurement. In this test method, the gas stream will be referred as air, though it could be any another gas that exhibits ideal gas law behavior.

1.2 This test method is not restricted to any particular tracer gas although experimental experience has shown that certain gases are used more readily than others as suitable tracer gases. It is preferable that the tracer gas not be a natural component of the gas stream.

1.3 Use of this test method requires a knowledge of the principles of gas analysis and instrumentation. Correct use of the formulas presented here requires consistent use of units.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 7.

More ASTM standard pdf

ASTM D2414-11

ASTM D2414-11

Standard Test Method for Carbon Black-Oil Absorption Number (OAN)

$30.00 $60.00

ASTM E455-11

ASTM E455-11

Standard Method for Static Load Testing of Framed Floor or Roof Diaphragm Constructions for Buildings

$30.00 $60.00

ASTM C1320-05

ASTM C1320-05

Standard Practice for Installation of Mineral Fiber Batt and Blanket Thermal Insulation for Light Frame Construction

$26.00 $52.00

ASTM D1586-11

ASTM D1586-11

Standard Test Method for Standard Penetration Test (SPT) and Split-Barrel Sampling of Soils

$30.00 $60.00