• ASTM E2154-15

ASTM E2154-15

Standard Practice for Separation and Concentration of Ignitable Liquid Residues from Fire Debris Samples by Passive Headspace Concentration with Solid Phase Microextraction (SPME)

ASTM International, 03/01/2015

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/03/2015

Pages:3

File Size:1 file , 65 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice describes the procedure for removing small quantities of ignitable liquid residues from samples of fire debris. An adsorbent material is used to extract the residue from the static headspace above the sample. Then, analytes are thermally desorbed in the injection port of the gas chromatograph (GC).

1.2 This practice is best suited for screening fire debris samples to assess relative ignitable liquid concentration and for extracting ignitable liquid from aqueous samples.

1.3 This practice is suitable for extracting ignitable liquid residues when a high level of sensitivity is required due to a very low concentration of ignitable liquid residues in the sample.

1.3.1 Unlike other methods of separation and concentration, this method recovers a minimal amount of the ignitable residues present in the evidence, leaving residues that are suitable for subsequent resampling.

1.4 Alternate separation and concentration procedures are listed in Section 2.

1.5 This standard cannot replace knowledge, skill, or ability acquired through appropriate education, training, and experience and should be used in conjunction with sound professional judgment.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D7038-18

ASTM D7038-18

Standard Test Method for Evaluation of Moisture Corrosion Resistance of Automotive Gear Lubricants

$41.00 $83.00

ASTM D7195-06(2012)

ASTM D7195-06(2012)

Standard Guide for Protocol for Setting Color Specifications for a Material

$30.00 $60.00

ASTM F996-98(2003)

ASTM F996-98(2003)

Standard Test Method for Separating an Ionizing Radiation-Induced MOSFET Threshold Voltage Shift Into Components Due to Oxide Trapped Holes and Interface States Using the Subthreshold Current-Voltage Characteristics

$29.00 $58.00

ASTM C1550-12

ASTM C1550-12

Standard Test Method for Flexural Toughness of Fiber Reinforced Concrete (Using Centrally Loaded Round Panel)

$33.00 $67.00