• ASTM E2251-14(2021)

ASTM E2251-14(2021)

Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids

ASTM International, 12/01/2021

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/12/2021

Pages:18

File Size:1 file , 220 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''The purpose of this standard is to specify liquid-in-glass ASTM thermometers using low hazard thermometric liquids defined in this standard.

1.2''This standard specifies liquid-in-glass thermometers graduated in degrees Celsius or degrees Fahrenheit that are frequently identified and used in methods under the jurisdiction of the various technical committees within ASTM. The current approved thermometers are listed in Table 1.

1.3''The technical requirements for the thermometric liquids used in the thermometers in Table 1 are specified in Annex A1. Tests for conformity to the technical requirements are also found in Annex A1.

Note 1:''It has been found by experience that ASTM Thermometers, although developed in general for specific tests, may also be found suitable for other applications, thus precluding the need for new thermometer specifications differing in only minor features. However, it is suggested that technical committees contact E20.05 before choosing a currently designated thermometer for a new method to be sure the thermometer will be suitable for the intended application.

1.4''For full rationale, see Appendix X1.

1.5''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM B116-95(2012)

ASTM B116-95(2012)

Standard Specification for Figure-9 Deep-Grooved and Figure-8 Copper Trolly Wire for Industrial Haulage

$30.00 $60.00

ASTM D69-06

ASTM D69-06

Standard Test Methods for Friction Tapes

$30.00 $60.00

ASTM B470-02(2012)

ASTM B470-02(2012)

Standard Specification for Bonded Copper Conductors for Use in Hookup Wires for Electronic Equipment

$26.00 $52.00

ASTM E741-00(2006)e1

ASTM E741-00(2006)e1

Standard Test Method for Determining Air Change in a Single Zone by Means of a Tracer Gas Dilution

$33.00 $67.00