• ASTM E23-23

ASTM E23-23

Standard Test Methods for Notched Bar Impact Testing of Metallic Materials

ASTM International, 01/01/2023

Publisher: ASTM

File Format: PDF

$49.00$98.00


Published:01/01/2023

Pages:27

File Size:1 file , 1.2 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods describe notched-bar impact testing of metallic materials by the Charpy (simple-beam) test and the Izod (cantilever-beam) test. They give the requirements for: test specimens, test procedures, test reports, test machines (see Annex A1) verifying Charpy impact machines (see Annex A2), optional test specimen configurations (see Annex A3), designation of test specimen orientation (see Terminology E1823), and determining the shear fracture appearance (see Annex A4). In addition, information is provided on the significance of notched-bar impact testing (see Appendix X1), and methods of measuring the center of strike (see Appendix X2).
1.2 These test methods do not address the problems associated with impact testing at temperatures below -196 °C (77 K).
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1 Exception-Section 9 and Annex A4 provide inch-pound units for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 6.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM A959-03

ASTM A959-03

Standard Guide for Specifying Harmonized Standard Grade Compositions for Wrought Stainless Steels

$30.00 $60.00

ASTM B593-96(2003)

ASTM B593-96(2003)

Standard Test Method for Bending Fatigue Testing for Copper-Alloy Spring Materials

$30.00 $60.00

ASTM D3524-04

ASTM D3524-04

Standard Test Method for Diesel Fuel Diluent in Used Diesel Engine Oils by Gas Chromatography (Withdrawn 2013)

$30.00 $60.00

ASTM A852/A852M-03

ASTM A852/A852M-03

Standard Specification for Quenched and Tempered Low-Alloy Structural Steel Plate with 70 ksi [485 MPa] Minimum Yield Strength to 4 in. [100 mm] Thick

$26.00 $52.00