1.1 These test methods apply to trowel, roller, or spray applied Water-resistive barrier (WRB) coatings that are applied over exterior sheathing prior to application of EIFS or EIFS with drainage wall claddings.
1.2 Test methods for in place wall system and cladding related to tests such as fire resistance, wind load capability, air barrier performance, and so forth. should also be considered but are outside the scope of this document.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
More ASTM standard pdf
ASTM D6345-98(2004)e1
Standard Guide for Selection of Methods for Active, Integrative Sampling of Volatile Organic Compounds in Air
$30.00 $60.00
ASTM A944-05
Standard Test Method for Comparing Bond Strength of Steel Reinforcing Bars to Concrete Using Beam-End Specimens
$26.00 $52.00
ASTM D4005-92(2005)
Standard Test Method for Plastic-Coated Fabrics - ;Completeness of Fusion of PVC Dispersion Coatings
$26.00 $52.00
ASTM D4464-00(2005)
Standard Test Method for Particle Size Distribution of Catalytic Material by Laser Light Scattering
$26.00 $52.00