• ASTM E2634-08

ASTM E2634-08

Standard Specification for Flat Wall Insulating Concrete Form (ICF) Systems

ASTM International, 11/01/2008

Publisher: ASTM

File Format: PDF

$31.00$62.00


Published:01/11/2008

Pages:6

File Size:1 file , 140 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification is intended to apply to Insulating Concrete Form (ICF) Systems that will act as permanent formwork for cast-in-place reinforced concrete beams; lintels; exterior and interior, above and below grade bearing and non-bearing walls; foundation; and retaining walls. The specification is restricted to ICF Systems with a resultant uniform monolithic concrete core.

1.2 Products covered by the specification consists of molded expanded polystyrene (EPS) insulation panels that are connected by cross ties to form the ICF System.

1.3 This specification identifies test methods appropriate for establishing ICF System performance in their primary function as a stay in place concrete forming system. The use of ICF Systems covered by this specification shall be regulated by building codes that address fire performance, structural performance or both. The fire performance of the material shall be addressed through standard fire test methods established by the appropriate governing documents. The structural performance must be addressed through design of concrete structures in accordance with the appropriate Code requirements.

1.4 Details of manufacturing procedures are beyond the scope of this specification.

1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. For conversion to metric units other than those contained in this specification, refer to IEEE/ASTM SI 10.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D1193-99e1

ASTM D1193-99e1

Standard Specification for Reagent Water

$26.00 $52.00

ASTM D244-04

ASTM D244-04

Standard Test Methods and Practices for Emulsified Asphalts

$33.00 $67.00

ASTM D1683/D1683M-17(2018)

ASTM D1683/D1683M-17(2018)

Standard Test Method for Failure in Sewn Seams of Woven Fabrics

$28.00 $56.00

ASTM D3380-90(1995)e1

ASTM D3380-90(1995)e1

Standard Test Method for Relative Permittivity (Dielectric Constant) and Dissipation Factor of Polymer-Based Microwave Circuit Substrates

$32.00 $65.00