• ASTM E2832-12(2017)

ASTM E2832-12(2017)

Standard Test Method for Measuring the Coefficient of Retroreflected Luminance of Pavement Markings in a Standard Condition of Continuous Wetting (RL-2)

ASTM International, 11/01/2017

Publisher: ASTM

File Format: PDF

$27.00$54.00


Published:01/11/2017

Pages:13

File Size:1 file , 2 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers a measurement of the wet retroreflective (RL-2) properties of horizontal pavement marking materials, such as traffic stripes and road surface symbols. A standardized method utilizing a standardized continuous wetting device and a portable retroreflectometer is described to obtain measurements of the wet retroreflective properties of horizontal pavement markings.

1.2 Retroreflective performance obtained with this test in a standardized condition of continuous wetting does not necessarily relate to how markings perform in all conditions of natural rain.

Note 1: Test Method E2177 may be used to describe the retroreflective properties of pavement markings in conditions of wetness, such as after a period of rain.

1.3 This test method is suitable for measurements made in the laboratory and in the field when the necessary controls and precautions are followed.

1.4 This test method specifies the use of external beam retroreflectometers conforming to Test Method E1710.2 The entrance and observation angles required of the retroreflectometer in this test method are commonly referred to as “30 meter geometry.”2

1.5 The test method excludes the effects of rain between the vehicle and the marking.

1.6 Results obtained using this test method should not be the sole basis for specifying and assessing the wet retroreflective effectiveness of pavement marking systems. Users should complement the results of this test method with other evaluation results, such as nighttime visual inspections.

1.7 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E2081-00

ASTM E2081-00

Standard Guide for Risk-Based Corrective Action

$53.00 $107.00

ASTM B246-00

ASTM B246-00

Standard Specification for Tinned Hard-Drawn and Medium-Hard-Drawn Copper Wire for Electrical Purposes

$29.00 $58.00

ASTM E1688-00a

ASTM E1688-00a

Standard Guide for Determination of the Bioaccumulation of Sediment-Associated Contaminants by Benthic Invertebrates

$45.00 $91.00

ASTM B48-00

ASTM B48-00

Standard Specification for Soft Rectangular and Square Bare Copper Wire for Electrical Conductors

$29.00 $58.00