• ASTM E291-18

ASTM E291-18

Standard Test Methods for Chemical Analysis of Caustic Soda and Caustic Potash (Sodium Hydroxide and Potassium Hydroxide)

ASTM International, 01/01/2018

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/01/2018

Pages:16

File Size:1 file , 320 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods cover only the analyses usually required on the following commercial products:

1.1.1 Caustic soda (sodium hydroxide), 50 and 73 % liquors; anhydrous (solid, flake, ground, or powdered), and

1.1.2 Caustic potash (potassium hydroxide), 45 % liquor; anhydrous (solid, flake, ground, or powdered).

1.2 The analytical procedures appear in the following order:

Alkalinity (Total), Titrimetric (for 50 to 100 %
 NaOH and 45 to 100 % KOH)

3 to 4

Carbonate, Gas-Volumetric (0.001 g CO2, min)

4 to 7

Carbonate, Gravimetric (0.001 g CO2, min)

7 to 10

Chloride, Titrimetric, (0.001 g Cl, min)

10 to 11

Chloride, Potentiometric Titration (0.3 to 1.2 %)

11 to 12

Chloride, Ion Selective Electrode (0.6 to 120 μg/g)

12 to 13

Iron, Photometric (0.005 mg Fe, min)

13 to 15

Sulfate, Gravimetric, (0.002 g SO3, min)

15 to 16

Keywords

16

1.3 Units-The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard with the exception of inch-pound units for apparatus descriptions.

1.4 In determining the conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E29.

1.5 Review the current Safety Data Sheet (SDS) for detailed information concerning toxicity, first-aid procedures, handling, and safety precautions.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 6.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D430-06e1

ASTM D430-06e1

Standard Test Methods for Rubber Deterioration-Dynamic Fatigue

$30.00 $60.00

ASTM E2495-07

ASTM E2495-07

Standard Practice for Prioritizing Asset Resources in Acquisition, Utilization, and Disposition

$29.00 $58.00

ASTM E780-06

ASTM E780-06

Standard Test Method for Measuring the Insulation Resistance of Mineral-Insulated, Metal-Sheathed Thermocouples and Thermocouple Cable at Room Temperature

$30.00 $60.00

ASTM F1565-00(2006)

ASTM F1565-00(2006)

Standard Specification for Pressure-Reducing Valves for Steam Service

$29.00 $58.00