• ASTM E2952-17

ASTM E2952-17

Standard Specification for Air-Purifying Respiratory Protective Smoke Escape Devices (RPED)

ASTM International, 02/01/2017

Publisher: ASTM

File Format: PDF

$44.00$89.00


Published:01/02/2017

Pages:25

File Size:1 file , 960 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers the minimum requirements for the design, performance, testing, and certification of air-purifying respiratory protective smoke escape devices for immediate emergency evacuation without entry/re-entry.

1.2 The purpose of this specification shall be to provide minimum requirements for respiratory protective escape devices that provide limited protection for 15 min for escape from the by-products of fire, including particulate matter, carbon monoxide, other toxic gases, and the effects of radiant heat.

1.3 The requirements of this specification specify an air-purifying respiratory protective escape device with a laboratory-tested 15-min service life intended to provide head, eye, and respiratory protection from particulate matter, irritants, and toxic gases and vapors commonly produced by fire.

1.4 Controlled laboratory tests that are used to determine compliance with the performance requirements of this specification shall not be deemed as establishing performance levels for all situations to which individuals can be exposed.

1.5 This specification shall not apply to the requirements for provision, installation, or use of air-purifying respiratory protective smoke escape devices.

1.6 This specification shall not apply to respiratory protective escape devices intended for use in circumstances in which an oxygen deficiency (oxygen less than 19.5 % by volume) exists or might exist.

1.7 This specification is not intended to be used as a detailed manufacturing or purchase specification, but shall be permitted to be referenced as a minimum requirement in purchase specifications.

1.8 Units-The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D4246-97

ASTM D4246-97

Standard Specification for Ozone-Resistant Thermoplastic Elastomer Insulation For Wire and Cable, 90 degrees C Operation

$25.00 $50.00

ASTM F1843-97

ASTM F1843-97

Standard Practice for Sample Preparation of Transparent Plastic Films for Specular Gloss Measurements, on Membrane Switch Overlays

$27.00 $54.00

ASTM E449-08(2013)

ASTM E449-08(2013)

Standard Test Methods for Analysis of Calcium Chloride

$30.00 $60.00

ASTM D5421-05

ASTM D5421-05

Standard Specification for Contact Molded "Fiberglass" (Glass-Fiber-Reinforced Thermosetting Resin) Flanges

$30.00 $60.00