Your shopping cart is empty!
ASTM International, 04/01/2022
Publisher: ASTM
File Format: PDF
$34.00$68.00
Published:01/04/2022
Pages:6
File Size:1 file , 86 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This fire-test-response test method assesses the response of materials, products, and assemblies to controlled levels of heat flux with an external igniter.
1.2''The fire-test-response characteristics determined by this test method include the ignitability and time to burn-through of materials, products, and assemblies under well ventilated conditions.
1.3''Heat, smoke, and mass loss rate are not within the scope of this test method, but are addressed by Test Method E1623.
1.3.1''This test method uses the same burner as that described in Test Method E1623. Two burner types are described (Burner A and Burner B).
1.4''Specimens are exposed to a constant heat flux up to 50 kW/m² in a vertical orientation. Hot wires are used to ignite the combustible vapors from the specimen.
1.5''This test method has been developed for evaluations, design, or research and development of materials, products, or assemblies, or for code compliance. The specimen shall be tested in thicknesses and configurations representative of actual end product or system uses.
1.6''Limitations of the test method are listed in 5.7.
1.7''This test method is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.
1.8''Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.
1.9''The values stated in SI units are to be regarded as standard.
1.10''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific information about hazards is given in Section 7.
1.11''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Wrought Stainless Steels for Surgical Instruments
$29.00 $58.00
Standard Practice for Certification of Personnel Engaged in the Testing of Soil and Rock
$21.00 $42.00
Standard Test Method for Testing Antifouling Panels in Shallow Submergence
$30.00 $60.00
Standard Specification for Cold-Expansion Fittings With Metal Compression-Sleeves for Cross-Linked Polyethylene (PEX) Pipe