• ASTM E3263-22e1

ASTM E3263-22e1

Standard Practice for Qualification of Visual Inspection of Pharmaceutical Manufacturing Equipment and Medical Devices for Residues

ASTM International, 05/01/2022

Publisher: ASTM

File Format: PDF

$41.00$82.00


Published:01/05/2022

Pages:21

File Size:1 file , 1 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice provides statistically valid procedures for determining the visual detection limit of residues and the qualification of inspectors to perform the visual inspection of pharmaceutical manufacturing equipment surfaces and medical devices for residues.
1.2 This practice applies to pharmaceuticals (including active pharmaceutical ingredients (APIs); dosage forms; and over-the-counter, veterinary, biologics, and clinical supplies) and medical devices following all manufacturing and cleaning. This practice is also applicable to other health, cosmetics, and consumer products.
1.3 This practice applies to many types of chemical residues (including APIs, intermediates, cleaning agents, processing aids, machining oils, and so forth) that could remain on manufacturing equipment surfaces or medical devices that have undergone all manufacturing steps including cleaning.
1.4 This practice applies only to equipment or devices that have been justified through a Quality Risk Management program to have an acceptable hazard analysis, have cleaning processes that are repeatable and validated and where Visual Inspection can be relied upon to determine the cleanliness of the equipment at the residue limit justified by the HBEL.
1.5 The values stated in International System of Units (SI) units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D7905/D7905M-19e1

ASTM D7905/D7905M-19e1

Standard Test Method for Determination of the Mode II Interlaminar Fracture Toughness of Unidirectional Fiber-Reinforced Polymer Matrix Composites

$28.00 $56.00

ASTM E1270-88(2014)

ASTM E1270-88(2014)

Standard Test Method for Equal Arm Balances (Withdrawn 2021)

$31.00 $62.00

ASTM C506M-16a

ASTM C506M-16a

Standard Specification for Reinforced Concrete Arch Culvert, Storm Drain, and Sewer Pipe (Metric)

$29.00 $58.00

ASTM D4188-17

ASTM D4188-17

Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water

$21.00 $42.00