Your shopping cart is empty!
ASTM International, 06/01/2022
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/06/2022
Pages:14
File Size:1 file , 400 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This guide provides information to non-law enforcement first responders for the selection and use of body armor.
1.2''Non-law enforcement first responders, including but not limited to fire fighters, emergency medical service providers, fire investigators, and civilian/community response teams, require specialized guidance on types of body armor and their limitations, levels of protection, threat assessment, use and care, compatibility with other required protective gear, and training.
1.3''This guide is directed to authorities having jurisdiction (AHJs) and all non-law enforcement first responders and their agency or department leadership.
1.4''This guide is not intended for law enforcement and corrections personnel.
Note 1:''See NIJ SAG 0101.06.
1.5''This guide is divided into the following sections:
''
Section
Title
1
Scope
2
Referenced Documents
3
Terminology
4
Significance and Use
5
Managing a Body Armor Program
6
Understanding Protection Levels
7
Selecting the Appropriate Body Armor
8
Sizing Body Armor to the End User(s)
9
Guidance on Purchasing
10
Verifying that Your Body Armor is NIJ Certified
11
Fit, Coverage, and Wear Guidance
12
Fire Fighter Guidance for Body Armor Use with Turnout Gear
13
Inspection, Care, and Maintenance
14
Keywords
Annex A1
Risk Assessment Guidance
Appendix X1
Body Armor Program Management Guidance
Appendix X2
Comparison of NIJ Ballistic Protection Levels
Appendix X3
General Federal Government Grant Programs
1.6''The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.6.1''The user of this standard will identify the system of units to be used, and it is critical to ensure that any cross-referenced standards maintain consistency of units between standards.
1.7''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.8''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for ASTM Thermometers
$50.00 $101.00
Standard Test Method for Total Mercury in Coal and Coal Combustion Residues by Direct Combustion Analysis
$25.00 $50.00
Standard Test Method for Evaluation of Diesel Engine Oils in T-12 Exhaust Gas Recirculation Diesel Engine
$43.00 $86.00
Standard Specification for Carbon and High-Strength Low-Alloy Structural Steel Shapes, Plates, and Bars and Quenched-and-Tempered Alloy Structural Steel Plates for Bridges
$30.00 $60.00
