Your shopping cart is empty!
ASTM International, 02/01/2016
Publisher: ASTM
File Format: PDF
$41.00$83.00
Published:01/02/2016
Pages:28
File Size:1 file , 590 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers determination of the microindentation hardness of materials.
1.2 This test method covers microindentation tests made with Knoop and Vickers indenters under test forces in the range from 9.8 × 10-3 to 9.8 N (1 to 1000 gf).
1.3 This test method includes an analysis of the possible sources of errors that can occur during microindentation testing and how these factors affect the precision, bias, repeatability, and reproducibility of test results.
1.4 Information pertaining to the requirements for direct verification and calibration of the testing machine and the requirements for the manufacture and calibration of Vickers and Knoop reference hardness test blocks are in Test Method E92.
Note 1: While Committee E04 is primarily concerned with metals, the test procedures described are applicable to other materials.
1.5 Units-The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Low-Temperature Viscosity of Lubricants Measured by Brookfield Viscometer
$33.00 $67.00
Standard Specification for Thermoplastic Polyethylene Insulation for Electrical Wire and Cable
$23.00 $46.00
Standard Test Method for Formability of Thin Film Organic Coatings on Steel Over a Biaxially Stretched Dome
$25.00 $50.00
Standard Test Methods for Mechanical Testing of Steel Products-Metric
$32.00 $65.00