• ASTM E45-18a

ASTM E45-18a

Standard Test Methods for Determining the Inclusion Content of Steel

ASTM International, 06/01/2018

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/06/2018

Pages:20

File Size:1 file , 410 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods cover a number of recognized procedures for determining the nonmetallic inclusion content of wrought steel. Macroscopic methods include macroetch, fracture, step-down, and magnetic particle tests. Microscopic methods include five generally accepted systems of examination. In these microscopic methods, inclusions are assigned to a category based on similarities in morphology, and not necessarily on their chemical identity. Metallographic techniques that allow simple differentiation between morphologically similar inclusions are briefly discussed. While the methods are primarily intended for rating inclusions, constituents such as carbides, nitrides, carbonitrides, borides, and intermetallic phases may be rated using some of the microscopic methods. In some cases, alloys other than steels may be rated using one or more of these methods; the methods will be described in terms of their use on steels.

1.2 These test methods cover procedures to perform JK-type inclusion ratings using automatic image analysis in accordance with microscopic methods A and D.

1.3 Depending on the type of steel and the properties required, either a macroscopic or a microscopic method for determining the inclusion content, or combinations of the two methods, may be found most satisfactory.

1.4 These test methods deal only with recommended test methods and nothing in them should be construed as defining or establishing limits of acceptability for any grade of steel.

1.5 The values stated in SI units are to be regarded as the standard. Values in parentheses are conversions and are approximate.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F2389-23

ASTM F2389-23

Standard Specification for Pressure-rated Polypropylene (PP) Piping Systems

$28.00 $57.00

ASTM E2816-18

ASTM E2816-18

Standard Test Methods for Fire Resistive Metallic HVAC Duct Systems

$41.00 $83.00

ASTM F2230-08

ASTM F2230-08

Standard Guide for In-situ Burning of Oil Spills on Water: Ice Conditions

$29.00 $58.00

ASTM C307-03

ASTM C307-03

Standard Test Method for Tensile Strength of Chemical-Resistant Mortar, Grouts, and Monolithic Surfacings

$26.00 $52.00