• ASTM E502-06

ASTM E502-06

Standard Test Method for Selection and Use of ASTM Standards for the Determination of Flash Point of Chemicals by Closed Cup Methods

ASTM International, 06/15/2006

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:15/06/2006

Pages:6

File Size:1 file , 100 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the flash point of liquid and solid chemical compounds flashing from below 10 to 370°C (16 to 700°F). The procedures and apparatus in Test Methods D 56, D 93, D 3278, D 3828, and D 3941 are to be used. Modification to these procedures are specified for tests on solids and viscous liquids. The significance of the results obtained is discussed along with possible sources of error and factors that might cause interference.

1.2 Suggestions for adapting this procedure to mixtures of chemicals are included (see Appendix X2).

1.3 This test method should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials or assemblies under actual fire conditions. However, results of this test method may be used as elements of a fire risk assessment that take into account all of the factors that are pertinent to an assessment of the fire hazard of a particular end use.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See also Section 8.

More ASTM standard pdf

ASTM D6572-13e1

ASTM D6572-13e1

Standard Test Methods for Determining Dispersive Characteristics of Clayey Soils by the Crumb Test

$30.00 $60.00

ASTM D6048-07

ASTM D6048-07

Standard Practice for Stress Relaxation Testing of Raw Rubber, Unvulcanized Rubber Compounds, and Thermoplastic Elastomers

$33.00 $67.00

ASTM D5624-02

ASTM D5624-02

Standard Test Method for Determining the Transverse-Aggregate Spread Rate for Surface Treatment Applications

$26.00 $52.00

ASTM D3878-07

ASTM D3878-07

Standard Terminology for Composite Materials

$30.00 $60.00