Your shopping cart is empty!
ASTM International, 01/01/1997
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/01/1997
Pages:7
File Size:1 file , 74 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice covers the application and calibration of equipment using the flux leakage test method for detection of outer surface, inner surface, and subsurface discontinuities in ferromagnetic steel tubular products (Note 1) of uniform cross section such as seamless and welded tubing.
Note 1-The term "tube" or "tubular product" will be used to refer to both pipe and tubing.
1.2 This practice is intended for use on tubular products having outside diameters from approximately 1/2 to 24 in. (12.7 to 610 mm) with wall thicknesses to 1/2 in. These techniques have been used for other sizes, however, and may be so specified upon contractual agreement between the purchaser and the supplier.
1.3 This practice does not establish acceptance criteria; they must be specified by the using parties.
1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Guide for Prefabricated Panel and H-bar Insulation Systems for Vessels, Ducts and Equipment Operating at Temperatures Above Ambient Air
$26.00 $52.00
Standard Practice for Identification of Seized Drugs
$25.00 $50.00
Standard Test Method for Strontium-90 in Water
$30.00 $60.00
Standard Test Method for Radial Crush Strength of Extruded Catalyst and Catalyst Carrier Particles