• ASTM E580/E580M-08ae1

ASTM E580/E580M-08ae1

Standard Practice for Installation of Ceiling Suspension Systems for Acoustical Tile and Lay-in Panels in Areas Subject to Earthquake Ground Motions

ASTM International, 11/01/2008

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/11/2008

Pages:10

File Size:1 file , 370 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice covers installation of suspended ceiling systems and their additional requirements for two groups of buildings that are constructed to resist the effects of earthquake motions as defined by ASCE 7 and the International Building Code. These groupings are for Seismic Design Category C and Seismic Design Categories D, E and F.

1.2 The authority having jurisdiction shall determine the applicability of this practice.

1.3 Specification C 635 and Practice C 636 cover suspension systems and their installation without special regard to seismic lateral restraint needs. They remain applicable and shall be followed when this practice is specified.

1.4 This practice is not intended to stifle research and development of new products or methods. This practice is not intended to prevent the installation of any material or prohibit any design or method of construction not prescribed in this practice, provided that any such alternative has been substantiated by verifiable engineering data or full-scale dynamic testing that is acceptable to the authority having jurisdiction.

1.5 Ceiling areas of 1000 ft² [92.9 m²] or less shall be exempt from the lateral force bracing requirements of 5.2.8.

1.6 Ceilings constructed of gypsum board which is screw or nail attached to suspended members that support a ceiling on one level extending from wall to wall shall be exempt from the lateral force bracing requirements of 5.2.8.

1.7 Free floating ceilings (those not attached directly to any structural walls) supported by chains or cables from the structure are not required to satisfy the seismic force requirements provided they meet the following requirements:

1.7.1 The design load for such items shall equal 1.4 times the vertical operating weight.

1.7.2 Seismic interaction effects shall be considered in accordance with 5.7.

1.7.3 The connection to the structure shall allow a 360° range of motion in the horizontal plane.

1.8 The values stated in either inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems result in nonconformance with the specification.

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM F526-97(2003)

ASTM F526-97(2003)

Standard Test Method for Measuring Dose for Use in Linear Accelerator Pulsed Radiation Effects Tests

$32.00 $65.00

ASTM F1136M-10

ASTM F1136M-10

Standard Specification for Zinc/Aluminum Corrosion Protective Coatings for Fasteners [Metric] (Withdrawn 2011)

$25.00 $50.00

ASTM F2554-10

ASTM F2554-10

Standard Practice for Measurement of Positional Accuracy of Computer Assisted Surgical Systems

$32.00 $65.00

ASTM E1270-88(2003)

ASTM E1270-88(2003)

Standard Test Method for Equal Arm Balances

$29.00 $58.00