Your shopping cart is empty!
ASTM International, 05/01/2015
Publisher: ASTM
File Format: PDF
$21.00$42.00
Published:01/05/2015
Pages:4
File Size:1 file , 120 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the procedure for conducting the ball punch deformation test for metallic sheet materials intended for forming applications. The test applies to specimens with thicknesses between 0.008 and 0.080 in. (0.2 and 2.0 mm).
Note 1: The ball punch deformation test is intended to replace the Olsen cup test by standardizing many of the test parameters that previously have been left to the discretion of the testing laboratory.
Note 2: The modified Erichsen test has been standardized in Europe. The main differences between the ball punch deformation test and the Erichsen test are the diameters of the penetrator and the dies. Erichsen cup heights are given in SI units.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Heavy Vehicular Paving Brick
$26.00 $52.00
Standard Specification for Molded Expanded Perlite Block and Pipe Thermal Insulation
Standard Specification for Raw Castor Oil
$27.00 $54.00
Standard Test Methods for Carbon Black-Sulfur Content
$30.00 $60.00
