• ASTM E754-80(2022)

ASTM E754-80(2022)

Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints

ASTM International, 10/01/2022

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/10/2022

Pages:8

File Size:1 file , 500 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method provides procedures for determining the ability of individual masonry ties and anchors to resist extraction from a masonry mortar joint.
1.2 Two laboratory testing procedures are provided for use with test specimens which consist of a masonry tie or anchor embedded in mortar between twin stack-bonded masonry units.
1.2.1 Procedure A-For use with small (brick-size) masonry units.
1.2.2 Procedure B-For use with large (block-size) masonry units.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D2860/D2860M-18

ASTM D2860/D2860M-18

Standard Test Method for Adhesion of Pressure-Sensitive Tape to Fiberboard at 90 degree Angle and Constant Stress

$24.00 $48.00

ASTM D146/D146M-04(2012)e1

ASTM D146/D146M-04(2012)e1

Standard Test Methods for Sampling and Testing Bitumen-Saturated Felts and Woven Fabrics for Roofing and Waterproofing

$31.00 $62.00

ASTM F1294-97a(2003)

ASTM F1294-97a(2003)

Standard Terminology Relating to Automatic Identification Hard Copy Printing Systems

$29.00 $58.00

ASTM D4916-97

ASTM D4916-97

Standard Practice for Mechanical Auger Sampling

$25.00 $50.00