• ASTM E800-05

ASTM E800-05

Standard Guide for Measurement of Gases Present or Generated During Fires

ASTM International, 07/01/2005

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/07/2005

Pages:16

File Size:1 file , 220 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 Analytical methods for the measurement of carbon monoxide, carbon dioxide, oxygen, nitrogen oxides, sulfur oxides, carbonyl sulfide, hydrogen halides, hydrogen cyanide, aldehydes, and hydrocarbons are described, along with sampling considerations. Many of these gases may be present in any fire environment. Several analytical techniques are described for each gaseous species, together with advantages and disadvantages of each. The test environment, sampling constraints, analytical range, and accuracy often dictate use of one analytical method over another.

1.2 These techniques have been used to measure gases under fire test conditions (laboratory, small scale, or full scale). With proper sampling considerations, any of these methods could be used for measurement in most fire environments.

1.3 This document is intended to be a guide for investigators and for subcommittee use in developing standard test methods. A single analytical technique has not been recommended for any chemical species unless that technique is the only one available.

1.4 The techniques described herein determine the concentration of a specific gas in the total sample taken. These techniques do not determine the total amount of fire gases that would be generated by a specimen during conduct of a fire test.

1.5 This standard is used to measure and describe the response of materials, products, or assembles to heat and flame under controlled conditions but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D6683-01

ASTM D6683-01

Standard Test Method for Measuring Bulk Density Values of Powders and Other Bulk Solids

$25.00 $50.00

ASTM E2562-17

ASTM E2562-17

Standard Test Method for Quantification of Pseudomonas aeruginosa Biofilm Grown with High Shear and Continuous Flow using CDC Biofilm Reactor

$32.00 $64.00

ASTM B930-03(2017)

ASTM B930-03(2017)

Standard Test Method for Rating Grain Size and Frequency of Abnormally Large Grains in Cemented Tungsten Carbides (Hardmetals)

$28.00 $56.00

ASTM D5171-09a

ASTM D5171-09a

Standard Test Method for Impact Resistance of Plastic Sew-Through Buttons

$26.00 $52.00