Your shopping cart is empty!
ASTM International, 11/01/2018
Publisher: ASTM
File Format: PDF
$24.00$48.00
Published:01/11/2018
Pages:9
File Size:1 file , 270 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers measuring the performance of solid waste size-reduction equipment.
1.2 This test method can be used to measure the flow (that is, throughput) of solid waste through the size-reduction equipment, energy usage of the size-reduction device, and particle size of the shredded product.
1.3 This test method includes instructions for measuring energy usage, solid waste throughput, net processing time, and particle size distribution.
1.4 This test method applies only to size-reduction equipment that produces a shredded product with a size corresponding to 90 % cumulative passing in the range of 0.5 to 15 cm (0.2 to 6 in.) on an air-dry weight basis. For material with nominal sizes outside of this range, the precision and bias statements for particle size designation (Section 14) may not apply.
1.5 This test method can be applied to size-reduction equipment located anywhere within a processing line.
1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6.1 Exception-The values given in parentheses are for information only.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Section 7 for specific hazard information.
1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Testing Fracture of Level Paintbrush Filaments
$25.00 $50.00
Standard Specification for Zirconium and Zirconium Alloy Forgings
$26.00 $52.00
Standard Specification for Petroleum Used for Blending with Creosote (Withdrawn 2006)
Standard Test Method for Calculation of Volume and Weight of Industrial Aromatic Hydrocarbons [Metric]
$30.00 $60.00