Your shopping cart is empty!
ASTM International, 06/01/2017
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:01/06/2017
Pages:4
File Size:1 file , 81 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice covers a procedure for the isolation of carbides, borides, TCP (topologically close-packed), and GCP (geometrically close-packed) phases (Note 1) in nickel and nickel-iron base gamma prime strengthened alloys. Contamination of the extracted residue by coarse matrix (gamma) or gamma prime particles, or both, reflects the condition of the alloy rather than the techniques mentioned in this procedure.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (See 4.3.2.1 and 5.1.1.)
Note 1: Ni3 Ti (eta phase) has been found to be soluble in the electrolyte for some alloys.
FIG. 1 Schematic Diagram of Extraction Cell
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Relative Cure of Energy-Cured Inks and Coatings
$22.00 $44.00
Standard Specification for Standard Metric Sizes of Electrical Conductors
$21.00 $42.00
ASTM Book of Standards Volume 01.09: Iron and Steel Products - Fasteners; Rolling Element Bearings
$143.00 $286.48
Standard Specification for Flexible Pre-Insulated Plastic Piping
$24.00 $48.00